Nylon Webbing 3/4"

$0.49

Available in store. Online ordering is paused — call or stop by the shop and we'll set this aside for you.

Ships nationwide · or free in-store pickup

Narrow but strong. 3/4 nylon webbing is for the gear straps that take a real pull but need to fit small hardware — the ones where 1" will not thread and polypro is not tough enough.

Choosing the 3/4 Nylon Webbing Width

Match the hardware, not the old strap. Buckles, slides and ladderlocks are cut to a nominal webbing width, and webbing that has been under load for years measures slightly narrow. If you have the buckle, bring it; if you have the whole strap, bring that and we will size it at the counter in ten seconds.

3/4" is common on packs, soft coolers, chairs, cart frames and smaller dry bags. One inch takes over for cargo and seat straps.

Why Nylon Here

Abrasion resistance, mostly. A narrow strap concentrates the same load into less material, so anything that rubs — a buckle edge, a hull rail, a cart frame — works on it harder. Nylon handles that far better than polypropylene, and it is the stronger fibre to begin with.

3/4 nylon webbing also stretches a little under load, which takes the shock out of a sudden pull rather than passing it straight into the stitching.

Two honest drawbacks: it absorbs water, so it dries slowly and is slightly weaker wet, and it sinks. For a strap that lives permanently soaked and might go overboard, our polypro is the better pick.

Making a Strap From 3/4 Nylon Webbing

Cut the length you need, seal both ends with a lighter and press them flat while soft. Thread a side release buckle on one end and a tri-glide on the other and you have an adjustable strap. Double-pass the webbing through each piece of hardware — a single pass creeps under load.